Sea-Doo Dash Engine Temperature Display

Our Dash-ECT module enables the display of engine temperature on your 2019 and newer Sea-Doo watercraft which no longer have this as a build in feature. Simply plug it into the diagnostic port and instantly get the engine coolant temperature displayed on your cluster. No need to run wires from the ECU or installing additional sensors, it’s a 100% plug & play installation and can be removed at any time.

The Dash-ECT module makes use of the existing lake water temperature channel on the cluster.  This means the engine temperature will be displayed where the lake water temperature is normally shown.  If your Sea-Doo has a factory lake water temperature feature than the engine temperature will override the lake water temperature.

VIP Color Cluster

Temperature displayed at all times.

Mono Cluster

Navigate to Water Temperature setting to display the engine temperature.

Limitation (imperial units only)

Because we use the lake water temperature channel on the cluster, we have a hard limit of how high of a number that can be displayed.  On the VIP color cluster the maximum number that can be displayed is 192, which means, when your units are set to imperial, the maximum temperature display will be 192F.  On the mono orange cluster, this limit is slightly higher at 194. Keep in mind that it will be rare to reach those hard limits since recent Sea-Doo models use 175F thermostat.

Clusters set to metric units are not affected by this limitation.

INSTALLATION

To install the module simply plug it into the diagnostic port as shown on the image below.